| Quick facts | Answer |
|---|---|
| Cost range | About $800 to $2,500; EPA average roughly $1,200 |
| Time | Most installs take 3 to 5 hours; complex jobs a full day |
| Who's qualified | Kentucky-certified (NRPP/NRSB) radon mitigation contractor, as state law requires |
Richmond, KY: what's different here
Richmond is the seat of Madison County, Kentucky, about 23 miles and roughly 27 minutes from Lexington by car via I-75 North. Kentucky sits in EPA Radon Zone 2, meaning moderate radon potential with predicted average indoor screening levels between 2 and 4 pCi/L. The median indoor radon level in Kentucky is about 3.5 pCi/L, just under the EPA action level of 4 pCi/L. That makes testing and, when needed, radon suction point installation worthwhile for Richmond homeowners.
What does radon suction point installation involve?
A suction point is a hole made in the slab so a pipe can draw radon from the soil below the house. This is the core of soil suction, which the EPA describes as drawing radon from below the home and venting it through pipes above the roof where it is diluted. Some homes need more than one suction point, which can extend the job to a full day.
Who can install a suction point in Richmond, KY?
Kentucky law says no person or business may conduct radon mitigation without the appropriate state certification. Radon mitigation must be done by a licensed radon mitigation contractor. You can verify a contractor through the state radon office at radon.ky.gov or 502-782-2782.
When should a Richmond home get a suction point?
The EPA says homes with radon levels of 4 pCi/L or more should be fixed, and a qualified mitigator should estimate the cost of upgrading to an active system. Kentucky is EPA Radon Zone 2, with predicted average indoor screening levels between 2 and 4 pCi/L, so testing first is the right move. Free test kits are available through the Kentucky Radon Program.
What does a radon system cost to run in Richmond?
An active radon fan runs continuously at 100 to 300 watts, which can add about $30 to $300 per year to your energy bill. The EPA recommends retesting at least every two years after mitigation to confirm levels stay low. Retesting is quick with a free state kit.
How fast can a Richmond installation happen?
Richmond is about 23 miles from Lexington via I-75 North, roughly a 27-minute drive. A professional sub-slab depressurization system can typically be installed in a single day, with many jobs taking about 3 to 5 hours. More complex jobs involving crawl spaces or multiple suction points may take a full day.
What to do next
- {'text': 'Test your home first with a free kit from the Kentucky Radon Program at (502) 564-4856 or a county library through Radon on the RADAR.'}.
- {'text': "Verify the contractor's certification at radon.ky.gov or by calling the state radon office at 502-782-2782."}.
- {'text': "Ask for proof of the contractor's Kentucky radon mitigation license before work starts."}.
- {'text': 'Get a written quote covering the suction point, pipe run, fan, and expected radon level after installation.'}.
- Call (859) 249-8571 or email [email protected] for a free quote from a Kentucky-certified (NRPP/NRSB) radon mitigation contractor.
Lexington Radon Pros is a free referral service: an independent contractor does the work and may pay us a referral fee. You never pay us anything.
